10.1 Electric pump
The automatic bilge pump drains water from the bilge when the surface sensor detects water:
The pump activates when the sensor has been fully submerged for 10 seconds.
-
It deactivates when the sensor has been dry for more than two seconds.
The pump is always on standby when the battery is connected, regardless of the position of the main switch.
If the bilge pump is running constantly it could indicate a leak in the hull.
Do not disconnect the bilge pump when the boat is in the water.
You can also activate the automatic pump manually:
The switch is located in the steering console.
This switch is equipped with a light that turns on when the pump is operating.
If the light does not activate, check the fuse of the bilge pump.
If the fuse is intact and the pump still does not start, consult an authorized dealer for repairs.